Sig sauer 9mm pistols serial#

The slide features flat-bottomed serrations at the front and rear. The lightening cut on the slide looks good and also reduces felt recoil. The front sight is the SIG X-Ra圓 night sight. While I think this looks good, it isn’t just for show reduced reciprocating weight means less felt recoil, and the X-Carry is meant to be maximized for performance as well as looks. There is a trapezoidal lightening cut in the top of the slide between the barrel hood and the front sight. Construction of the P320 is about as corrosion-resistant as you can get, which didn’t hurt in the military trials. The slide is stainless steel with a black Nitron finish. There is absolutely no vertical play, so it appears this gun has been tweaked on the inside as well as the outside. The X-Carry barrel has the same locking block as a standard P320, but it offers a much tighter fit than on a standard P320. It is supplied with three 17-round magazines and a cable lock in a lockable plastic case. Right now there is only one version of the X-Carry available, and that version is all black and chambered in 9mm. With an empty magazine inserted, the pistol weighs just under 27 ounces. The X-Carry is 7.4 inches long including the beavertail and 5.5 inches tall with a magazine in place, which means this is far from a pocket pistol and you will need a good holster and a covering garment up to the task. The X-Carry features a top end the length of the original P320 Compact, with a 3.9-inch barrel with target crown, but with a full-length grip. The standard full-size P320 has a 4.7-inch barrel and full-length grip, and the standard Compact P320 has a 3.9-inch barrel and a shorter grip with 15-round flush magazines in 9mm. It also sports the full-length grip that, in 9mm, accommodates flush 17-round magazines. The full-house competition X-Five has the longest barrel of any P320 at five inches even. Then SIG introduced the X-series guns, and the multitudes cried with joy. I bought a spare grip module for my P320 Compact and did some grinding and stippling to it, but there wasn’t much I could do about the grip angle. This didn’t seem to affect its shootability, but I was not alone in wishing for a more-angled grip. The grip angle on the original P320 is more vertical than on most modern firearms. The sights on the P320 are steel, and you have your choice of three-dot or three-dot night sights. The trigger itself is steel, and the trigger pulls on these guns always had nice, crisp breaks for striker-fired guns, although at six to seven pounds, they were a bit heavier than I prefer. Trigger pull on the P320 was always good. The frame is undercut behind the trigger guard for a high grip, but most noticeable is the 90-degree trigger break, which helps eliminate side-to-side play during the pull. You can also change calibers by swapping out the top end. You then can swap out your grip modules for ones fatter or thinner, longer or shorter, to change the size and capacity of your firearm. Removing the chassis from the grip module takes just a few seconds. Yes, I know the new model features what SIG first was calling the “X-Frame,” but someone must have reminded the company that it isn’t the frame, because now it is referred to as the “X-series grip.”

Sig sauer 9mm pistols serial#

The part containing the serial number, the actual “firearm,” is the stainless steel chassis inside the grip module. Unlike most pistols, what looks like the polymer frame of this striker-fired pistol isn’t actually the frame it is just the grip module. 40 S&W, although the 9mm version is by far the most popular. This is a polymer-framed striker-fired pistol with an ambidextrous slide stop/release and a reversible magazine release. Let’s start with the basics of the P320 and work our way up to the X-Carry’s upgrades. SIG’s X-Carry model is meant to be the P320 tweaked to ultimate concealed-carry perfection. Then SIG introduced the X-frame models (X-Five and VTAC), which seemed to address every complaint I had with the platform, however minor. Army adopted a version of the P320 as its new M17 service pistol, I realized I had underestimated the P320.

Basically a striker-fired version of SIG’s modular double-action/single-action P250, the gun was reliable and had a nice trigger, but I thought it could have been so much more.Įven before the U.S. When the SIG P320 was introduced in 2014, I received one of the first models and reviewed it in these pages. It’s amazing how the landscape can change in just a few short years.